Note: Resetting the goggles will erase any swims or configuration from memory. They will return to the factory state and must be paired again to a phone in order to use them.

In-Goggles Reset

If you need to reset your goggles, power on the goggles and navigate to the “settings” menu. From here, go to “reset goggles” and confirm to begin the reset.

If the goggles are unresponsive, you may need to perform a reset using one of the following button sequences. If the sequence is input incorrectly, the goggles will attempt to power on normally.

Button Sequence Reset - Smart Swim 2

1. Ensure your goggles are charged and powered off
2. Press and hold the REAR button, then while still holding down the REAR button, press and hold the FRONT button until the display turns on, then follow the prompts.

It may take a few minutes to complete the reset, after which they will return to the state they were in out of the box.

Button Sequence Reset - Smart Swim 1

1. Ensure your goggles are charged and powered off

2. Press and hold the REAR button, then while still holding down the REAR button, press and hold the FRONT button until the red LED blinks twice then release both buttons.

3. Hold down the REAR button until the LED blinks once then release the button

4. Hold down the FRONT button until the LED blinks once then release the button

5. Hold down the REAR button until the LED blinks once then release the button

6. Hold down the FRONT button until the LED blinks twice and the display will indicate that the reset has begun.

It may take a few minutes to complete the reset, after which they will return to the state they were in out of the box.